Scanning Options - Stop Scanner On

System Errors

When this check box is checked, ScanTools software stops scanning whenever any error is encountered.

When the currently configured scanner does not have a select stacker, stopping on any error is mandatory. In this case, this option is always checked; it is disabled and you cannot change it.

When the currently configured scanner has an integrated select stacker or has an optional select stacker installed and configured, you can uncheck this option. In this case, when one of the system errors listed below is encountered, the sheet will go to the select stacker and scanning continues to the next sheet. "System Error" will be displayed in the Scanning Progress dialog for the selected sheet.

• Form ID mark error

• Timing mark error

NOTE: For OpScan 3/4/4U and iNSIGHT 4 scanners, determine whether the scanner has a select stacker and check or uncheck the Select Stacker option in the Scanner Configuration dialog as needed. If ScanTools' knowledge of your scanner configuration is incorrect and it is told there is a select stacker when there is not one, it may result in unrecognized sheets being ignored when the Stop Scanner On System Errors check box is unchecked.

Thickness Errors (scanner controls errors)

The default value is checked (ON). This causes the scanner (not the ScanTools application) to control thickness checking and stop scanning when a thickness error is detected.

NOTE: If this option is ON, you cannot scan a batch of forms that vary in thickness.

If this box is NOT checked, the ScanTools application controls thickness checking based on the Sheet Thickness value defined in the New Document or Select Document dialog. For more information, see Sheet Thickness Checking.

• iNSIGHT20 and iNSIGHT 30 Scanners: This setting is ignored by the iNSIGHT 20 and iNSIGHT 30 scanners. The iNSIGHT 20 and iNSIGHT 30 scanners do not perform thickness checking, whether or not this is checked or if values are defined in the application.

• EZData Scanner: This setting is ignored by the EZData scanner. The EZData scanner does not perform thickness checking, whether or not this is checked or if values are defined in the application.

Litho-code Errors

When this check box is checked, ScanTools software stops scanning when a Litho-code error is encountered by the scanner, and an error message is displayed. If this is not checked, Litho-code are not checked, and no errors are reported. A Litho-code is an optional binary-coded serial number that is unique to every form. They are pre-printed grids that are used to check that all sheets in a booklet are from the same individual document.